The JX-3P Upgrade features:

•256 Tones, 8 Sequences & 16 Patterns can be stored and edited, Sequences & Patterns can be optionally linked to tones. It is also possible to temporarily edit any Tone, Seq or Pattern.

•MidiCC support for all parameters, Midi Sysex support for Tone Dump & Load.

•Patch Editor Control of Parameters (requires PE v 4.1 or later), Tones have 89 editable parameters.

•8 separate 124 max step polyphonic sequences. These can be clocked from the internal/external sequencer clock, Pattern Generator, LFO2 or midi clock divided by 3,4,6,9,12,18,24,36,48,72,96,128,144,168 or 192

•Polyphonic, Unison and Mono Key Assign Modes

•Portamento in Unison, Mono, Arp & Chord modes

•DCO Key Assign Detune available in all key modes, DCO 1 & 2 have separate Tune controls (+-12 semitones).

•Master Synth Fine Tune adjust•Two independent  envelope generators.

•Two independent Low Frequency Oscillators. LFO2 random2 can be clocked from the sequencer clock. The Arp, Pattern and Sequence clocks can be optionally sourced from the LFO2.

•16 stored Pattern Generator patterns. These can be clocked from the internal/external clock, LFO2 or midi clock divided by 3,4,6,9,12,18,24,36,48,72,96,128,144,168 or 192. The pattern can be any length between 2 and 16 steps.

•Pattern Play Mode. This can be faded from no effect to full effect.•Aftertouch, Modulation Level and dynamics via midi.

•Modulation options include Velocity, Aftertouch and midi modulations that can be used in any combination. Each ENV Mod can select from ENV 1 or 2 and is a split control with add (normal) and subtract (inverted)•LFO Button can inject mod control to any mod destination(s)

•LFOs can be plus or minus base note or plus only•Bend Lever can be directed to Osc, Filter, LFO Rate and VCA Level in any combination.

•Chord Mode. Any chord with up to 6 notes can be set and played from any key•Enhanced Parameter editing to allow editing of all 89 Tone parameters and 27 Global Parameters from the front panel•Sequencer, LFO 1 and LFO 2 clocks and voice use can optionally display on the front panel.

•Greater speed range and 6 waveforms for LFO1 and LFO2, LFO2 has a second Random mode that can be clocked from the Sequence Clock.

•The Arpeggiator can be clocked from the internal/external clock, Pattern Generator, LFO2 or midi clock divided by 3,4,6,9,12,18,24,36,48,72,96,128,144,168 or 192.

•Arp modes are Up, Down, Up and Down and Random, 0, 1 or 2 octaves.

•Key transpose allows transposition to any key Up or down up to 2 octaves. Sequencer key can be shifted to any key while playing by using Key Transpose.

•Sequencer can be Started, Stopped & Continued using Midi Commands•Appeggiator will Output Midi Data and Sequencer can optionally Output Midi.

•Overall Synth Fine Tune.

•Chorus has Manual Mode & variable speed.

•The PG-200 is not supported.